NP-100T NOTIFIER

NP-100T Notifier Intelligent Addressable Photo/Thermal Detector With Base.

The NP-100T Notifier addressable, low-profile plug-in photoelectric detectors use a state-of-the-art photoelectric sensing chamber with communications to provide open area protection and are used exclusively with Notifier’s FireWarden-100 Addressable Fire Alarm Control Panel (FACP).

The NP-100T Notifier adds thermal sensors that will alarm at a fixed temperature of 135°F (57°C). Since these detectors are addressable, they will help emergency personnel quickly locate a fire during its early stages, potentially saving precious rescue time while also reducing property damage.

Two LEDs on each sensor light to provide a local, visible sensor indication. Remote LED annunciator capability is available as an optional accessory (P/N RA400Z).

Features

SLC loop:
• Two-wire loop connection.
• Unit uses base for wiring. Addressing:
• Addressable by the device.
• Direct Decade 01 – 99 (FireWarden-100) entry of address.

Architecture

• Unique single-source, dual-chamber design to respond quickly and dependably to a broad range of fires.
• Sleek, low-profile design.
• Integral communications and built-in type identification.
• Built-in tamper-resistant feature.
• Removable cover and insect-resistant screen for simple field cleaning.

Operation

• Withstands air velocities up to 4,000 feet-per-minute (20 m/ sec.) without triggering a false alarm.
• Factory preset at 1.5% nominal sensitivity for panel alarm threshold level.
• Visible LED “blinks” when the unit is addressed (communicating with the fire panel) and latches on in alarm.

Mechanicals

• Sealed against backpressure.
• Direct surface mounting or electrical box mounting.
• Mounts to: single-gang box, 3.5″ (8.89 cm) or 4.0″ (10.16 cm) octagonal box, or 4.0″ (10.16 cm) square electrical box (using a plaster ring — included).

Other system features

• Fully coated circuit boards and superior RF/transient protection.
• 94-V0 plastic flammability rating.
• Low standby current.

Options

• Remote LED output connection (P/N RA400Z).